Guide

How to Use an Anova Precision Vacuum Sealer

Updated on · By the Ecoveganic team

To use the Anova Precision Vacuum Sealer Pro, load the bag roll in the built-in storage, open the lid, and lay the bag end across the sealing strip. Pick the wet or dry mode for your food, close the lid and hold it until the cycle ends, then let the seal cool before removing the bag.

On this page (9 sections)
  1. What do you need before your first seal?
  2. How do you load the bag roll and cut a bag?
  3. How do you pick wet or dry mode?
  4. How do you vacuum and seal a bag step by step?
  5. How do you seal jars, containers and wine bottles?
  6. Why does a bag lose its seal, and how do you fix it?
  7. Which bags should you buy for the Anova sealer?
  8. How do you keep the Anova sealer working well?
  9. What is the simple routine for using the Anova Precision Vacuum Sealer?

To use the Anova Precision Vacuum Sealer Pro, load a bag roll into the built-in storage, open the lid, and lay the open bag end flat across the sealing strip. Pick wet or dry mode for your food, close the lid and hold it shut until the cycle finishes, then let the seal cool before you handle the bag.

That one-handed routine covers most jobs: sous vide bags, freezer portions, and pantry staples. Once you know where the roll sits and how the two modes differ, the rest is practice with a few settings.

What do you need before your first seal?

Gather the sealer, its included bag roll, and something to cut the roll with, then read the short start-up page in the Anova instructions. The Pro ships with a 19-foot bag roll and a sliding cutter built into the top, so you don't need a separate roll or scissors to begin.

Plug the unit in and let it sit at room temperature if it was stored somewhere cold. Wipe the sealing strip and the gasket with a dry cloth before the first cycle, since dust or crumbs can break the seal.

You'll also want a clean, flat counter with room to lay a bag out straight. Clear space matters more than most people expect, because a bag that bends or folds at the sealing strip won't close properly.

How do you load the bag roll and cut a bag?

Open the top of the sealer to reach the roll compartment, drop the included roll in so it turns freely, and close the lid. Pull the free end toward the front cutter and slide the cutter across to trim the length you need.

Cut squarely across the roll, not at an angle. A straight edge gives the sealing strip a flat band to grip, while a slanted cut leaves a corner that can leak air.

For a freezer portion, allow about 3 inches of bag beyond the food so there's room for the vacuum and the seal. For a small item, cut a shorter length rather than sealing a mostly empty bag.

The built-in storage and cutter keep the roll tidy between sessions. That design is one of the reasons the Pro earns its place as a step up from Anova's simpler sealer.

How do you pick wet or dry mode?

Use dry mode for bread, cheese, coffee beans, and other low-moisture foods, and switch to wet mode for meat, marinades, and anything juicy. The wet setting runs low-pressure suction so liquid stays in the bag instead of getting pulled toward the pump.

The mode selector lists Vacuum & Seal, Moist, Dry, Seal, Pulse Vacuum, and External Pulse Vacuum. For a first bag of leftovers or a steak headed for the freezer, the matching vacuum mode is all you need.

If you're unsure, choose wet for anything that might drip. A slightly longer cycle is a small price for keeping the machine clean and the seal dry.

When should you use the Anova Precision Vacuum Sealer Pro for wet foods?

Reach for the Pro when you seal marinades, fresh fish, or meat with juices and want to avoid the mess that a standard sealer makes. The wet mode and double sealer work together to handle liquid at the bag opening.

Its accessory port also takes jar lids and containers, so you can extend the same pump to pantry storage. That makes it a useful first machine for anyone who moves between bags and jars.

Skip it if you mainly seal dry pantry goods and want the simplest possible routine. A basic single-mode sealer covers that job with fewer choices at the controls.

How do you vacuum and seal a bag step by step?

Place the open end of the bag flat across the sealing strip, close the lid, and hold it down until the cycle ends. The Pro is built to clamp, vacuum and seal with one hand, so keep your other hand free for the bag.

  1. Fill the bag and press the food flat, leaving a few inches of headspace.
  2. Smooth the bag opening so both edges line up evenly.
  3. Lay the open end across the strip without wrinkles or creases.
  4. Choose the matching wet or dry mode and press the start control.
  5. Hold the lid shut until the pump stops and the seal light finishes.
  6. Lift the bag out and lay it flat while the seal cools.

Listen for the pump to stop changing pitch, which means the air is out. If the bag still looks loose, run a seal-only cycle on a fresh section of bag rather than reusing a damp opening.

How do you seal jars, containers and wine bottles?

Fit the hose to the accessory port, attach the matching end to a vacuum-ready jar lid, container valve, or wine stopper, and start the external vacuum cycle. The pump pulls air through the fitting until the lid or stopper holds.

Press the control to stop the cycle when the lid seats or the container feels firm. Don't overrun it, since some soft containers can collapse if you keep pulling air.

This is handy for coffee, grains, and leftovers that don't suit a flat bag. It also lets you reseal an opened bottle of wine with a vacuum stopper made for the job.

Why does a bag lose its seal, and how do you fix it?

A bag usually loses its seal for one of four reasons: moisture or crumbs at the opening, a wrinkle in the seal band, too little headspace, or a bag material that doesn't channel air. Each one is easy to spot and fix.

Wipe the inside of the bag opening dry and trim off the old seal line before sealing again. Smooth out creases so the whole band sits flat against the strip.

Leave enough headspace that the food doesn't touch the seal area. If a bag keeps failing, check the bag type before blaming the machine; ordinary storage bags don't work in a vacuum sealer.

For a deeper checklist when the pump seems weak or won't pull air at all, our guide to why your vacuum sealer is not vacuuming walks through the common fixes.

When is a FoodSaver a better fit for bag sealing?

A FoodSaver suits households that seal mostly dry foods and want a wider range of accessories, and the FM2100 pairs a roll cutter with dual heat strips and an accessory hose. It seals moist and dry foods and comes with a starter roll and pre-cut bags.

FoodSaver backs it with a 5-year limited warranty and says sealed food keeps up to 3 years in the freezer. Those are the brand's claims, but they set expectations for how you'll use it.

Pick the FoodSaver over the Anova if you already own FoodSaver containers or a handheld sealer. Pick the Anova if wet foods and one-hand operation matter more to you.

Which bags should you buy for the Anova sealer?

Buy rolls or bags made for heat-sealing vacuum machines, not plain zip bags. FoodSaver's Custom Fit rolls are a strong general choice because you cut each length to fit the food and waste less bag.

The three-roll pack gives you 11-inch wide rolls at 16 feet each. The multi-layer material blocks oxygen and moisture, is BPA-free, and is safe for the freezer, fridge, microwave and boiling water.

Cut a straight edge and keep the bag dry at the opening, and the same roll works in the Anova as in a FoodSaver. For more ideas when you don't have a machine handy, see how to vacuum seal without a vacuum sealer.

How do you keep the Anova sealer working well?

Wipe the sealing strip and gasket after every session and store the unit closed, and the sealer will keep pulling a strong vacuum for years. Small habits prevent most sealing problems.

Let each seal cool before stacking bags or putting them in the freezer. Trim bags so no food sits in the seal band, and run a seal-only cycle to close the end of a roll between uses.

Keep the cord in the storage space underneath the unit and close the lid over the roll so dust stays out. For marinade projects, our guide to how to marinate steak with vacuum sealer shows how the wet mode speeds up flavor.

If your kitchen grows into bulk sealing and jars, a chamber vacuum sealer for home use removes air from liquid-heavy foods without a wet-mode setting. Compare that option before you buy a second countertop machine.

What is the simple routine for using the Anova Precision Vacuum Sealer?

The routine for how to use an Anova precision vacuum sealer is short: load the roll, cut a straight bag, match the mode to the food, and hold the lid through one cycle. Let the seal cool, then store the bag flat.

Keep a spare roll on hand and wipe the strip after each session. With those habits, the Pro handles freezer portions, sous vide bags, marinades and jar lids from one compact unit on the counter.

Frequently asked questions

Can the Anova Precision Vacuum Sealer Pro seal liquids?

Yes, its wet mode uses low-pressure suction so you can seal juicy foods and marinades without pulling liquid into the machine. Keep the bag upright and leave some headspace so the liquid stays below the sealing strip during the cycle.

How long should I let a bag rest after sealing?

Let the seal cool and set for a few seconds before you handle or freeze the bag. A hot seal is softer and can split if you pull on it right away, so leave the bag flat on the counter until it feels firm.

What does the accessory port do?

The accessory port and hose let the sealer pull air from canning jar lids, vacuum containers, and wine stoppers made for vacuum use. Attach the hose to the port and the matching fitting, then start the external vacuum cycle.